Ultra Plantâ„¢ Grow Light offers One Chip Technology aimed to meet your indoor growing expectation such as improve plants' quality, increase yield, or better the margin, etc., all for helping you realize a higher return on your crops.
From Ultra Plantâ„¢ APP, you are able to schedule the growing process including photoperiod, brightness and spectral in advance. The lighting system will help you grow smarter, easier and better.
150W Led Grow Light,Led Grow Lights,Best Led Grow Lights,T5 Grow Lights Feton Corporation , https://www.fetongrowlight.com
Ultra Plantâ„¢ Grow Light is combined our advanced All-In-One technology with patented optical design and customized light full spectrum supported from our experienced LED engineers, plant specialists and other partners working on horticulture.
Ultra Plantâ„¢ is the most versatile horticultural grow lighting fixture for indoor plants with flexible full spectrum, brightness control and uniform, wider light distribution, suitable for top lighting of all types of crops. No matter it applies to anywhere for any crop, Ultra Plantâ„¢ can do perfect work for you.
8 remedies for bending parts
Bending the molded part is injection-molded part due to the presence of defects in their features, the shape of the mold cavity injection molding but it is similar to the shape of the cavity warped version.
The reasons why the injection molded parts may be bent:
(1). The bending of the injection molded part is due to excessive internal stress in the injection molded part.
(2). The mold filling speed is slow, resulting in bending of the injection molded parts.
(3). The plastic in the cavity is insufficient, which causes the molded part to bend.
(4). The temperature of the plastic is too low or inconsistent, and it is also possible to bend by the injection molded part.
(5). The injection molded part is too hot when it is ejected.
(6). The cooling is insufficient or the temperature of the fixed and fixed molds is inconsistent.
(7). The structure of the injection molded parts is unreasonable (such as the reinforcing ribs are concentrated on one side, but far apart).
8 ways to remedy the bending of injection molded parts:
(1). Reduce the pressure of injection molding.
(2). Reduce the time forward of the screw.
(3). Increase the cycle time (especially the cooling time). Immediately after being ejected from the mold (especially thicker injection molded parts), it is immersed in warm water (38 oc) to allow the injection molded part to cool slowly.
(4). Increase the speed of injection molding.
(5). Increase the temperature of the plastic.
(6). Cool the curved injection molded parts with a cooling device.
(7). Appropriately increase the time for cooling and bending the injection molded parts or improve the cooling conditions, as far as possible to ensure that the mold temperature of the moving and fixed molds is consistent.
(8). Improve the structure of the curved injection molded parts as the case may be.