Wittur Selcom Elevator Door Parts
Wittur Elevator Door Parts, Selcom Elevator Door Parts, Selcom Lift Door Parts, Wittur Lift Door Parts
Since 1977 Wittur supplies the lift industry with versatile and high-quality doors. Design flexibility, coupled with full range of certifications, makes Wittur landing doors suitable for every application. A wide variety of available finishings and executions allows them to fit in every environment: from residential to exclusive office buildings, from exterior installations to luxurious marine projects, from industrial buildings to hospitals.
Hydra Plus car door Hydra Plus is a door system which can be used with any kind of application from residential buildings up to highly frequented office buildings and hotels.
AUGUSTA ECO door is a new type of car door for residential and affordable housing elevator application.
The bending sheet should be in the middle of the machine tool. Generally, it should not be biased, so as not to affect the bending effect and machine precision. If some workpieces need to be unilaterally processed, the load should not be greater than 1/4 of the nominal force, and both sides must be simultaneously Fold the board to avoid loading the sheets.
N46 hydraulic oil is added to the fuel tank. After the first use, it must be replaced by filtration and replaced within one year. The normal working oil temperature is 15-60 °C, and the mesh oil filter at the suction port is often cleaned to keep the oil suction unblocked, otherwise the oil pump will be sucked up, causing the machine to generate vibration and noise.
The machine is dispersively lubricated and lubricates each lubrication point during daily work.
The machine must be staffed and the operator must be familiar with the machine's use and safe operation.
The bending force of the workpiece is not allowed to exceed the nominal force.
In order to make the mold durable, do not damage the system due to the short length of the bent sheet and the excessive pressure of the system. Especially when bending the short sheet, the working pressure of the machine should be appropriately reduced, and the bending of the workpiece length should be guaranteed every 100mm. The force does not exceed 100kN.
The gap between the upper and lower molds is initially adjusted according to the thickness of the bent sheet material, and the gap can be about 1 mm larger than the thickness of the sheet, so that the mold is not crushed because the gap is too small.
More information http://
Wittur Elevator Door Parts, Selcom Elevator Door Parts, Selcom Lift Door Parts, Wittur Lift Door Parts
CEP Elevator Products ( China ) Co., Ltd. , https://www.zjfullelevatorreplacement.com