In the house interior space, sliding doors are widely used. For example, kitchens, toilets, balconies, and other areas are installed with sliding doors, which can not only effectively cut off space, but also make people look very beautiful and comfortable and have the effect of space saving. Then how to install the sliding door , the following article will take everyone to understand the next five steps to install the sliding door. How to install the sliding door: slide installation It is often desirable to install the slide when installing the sliding door. When the slide is installed, the door beam needs to be fixed according to the requirements of the width of the door opening and the opening direction. Usually, the center of the width of the door opening is used as a reference for fixing on two sides. Note that the connection between the slide and the door beam is The height needs to be the same, the centerline of the slideway needs to be the same as the size of the outer wall of the colorboard, and its size is preferably one half of the thickness of the fan and a gap of 2cm more. How to install the sliding door: door leaf installation Sliding door leaf and pulley systems are usually machined directly in the factory. After the upper slideway is installed, the pulley can be placed in the chute and then placed vertically by hand or other lifting tools. Underneath, at the same time, the screw on the door leaf is inserted into the bolt hole installed in the pulley and fixed. How to install the sliding door: door limiter After the installation of the door leaf of the sliding door is complete, it is necessary to start installing the door limiter. It is necessary to use the angle limiter at the bottom or inside of the upper slide to weld the position 10mm away from the edge of the pulley, so that the opening area of ​​the door leaf is limited to its effective Within range. The requirements for contact between the angle steel and the pulley must be more than 20mm, and a hard rubber pad can be used as buffer in the middle. How to install the sliding door: guide cake and door stopper installation After the door stopper is installed, the sliding door guide and door stopper can be started. Centering of the guide cake can be positioned according to the actual position of the flat steel under the door leaf. The guide cake needs to expose about 10 to 15 mm from the ground with a spacing of 500mm. When the limiter is installed, it needs to push the door leaf 10 to 20mm from the outside. Position, then fix the stopper with screws. How to install the sliding door: door hardware installation The final step is to install sliding hardware accessories. The sliding hardware accessories include handles, locks and so on. It is necessary to wait until the sliding door is adjusted correctly before installation. The height and position of the accessories must be installed correctly. This will make the sliding door look more beautiful. The article concludes: The above is about how to install the sliding door to the relevant introduction, hoping to let everyone know how to install the sliding door. At present, sliding doors are used widely in our lives and are very practical and exquisite. If there are other related requirements, please pay attention to Qijia Information. Aluminium High Speed Spiral Door Dongguan HengTaichang Doors Co, Ltd. , https://www.dghtcdoor.com
