Polishing with sandpaper requires the use of soft wood sticks or bamboo sticks. When polishing round or spherical surfaces, use cork sticks to better match the curvature of the round and spherical surfaces. The harder wood strips are like cherry wood, which is more suitable for the polishing of flat surfaces. In the process of making rapid molds and hand-shaped molds, there is often a procedure for polishing. The quality of the polishing directly affects the appearance of the final mold. This requires attention to those points when polishing the mold with sandpaper. Bathroom Wall Light Fixtures,Waterproof Shower Light,Chrome Vanity Light,Bathroom Lights Above Mirror NINGBO EASTKEY ILLUMINATE APPLIANCE CO.,LTD , https://www.eastkeylighting.com
First, in order to avoid scratching and burning the surface of the workpiece, special care must be taken when polishing with #1200 and #1500 sandpaper. It is therefore necessary to load a light load and polish the surface using a two-step polishing method. When polishing with each type of sandpaper, it should be polished twice in two different directions, with each rotation between 45° and 90°. Diamond grinding and polishing should pay attention to the following points: 1) This polishing must be carried out under light pressure as much as possible, especially when polishing pre-hardened steel parts and polishing with fine grinding paste. When polishing with #8000 abrasive paste, the common load is 100~200g/cm2, but it is difficult to maintain the accuracy of this load. To make this easier, you can make a thin and narrow handle on the strip, such as adding a piece of copper; or cut a part of the strip to make it softer. This helps control the polishing pressure to ensure that the mold surface pressure is not too high.
Second, trim the end of the strip so that it can match the shape of the surface of the steel, so as to avoid the acute angle of the strip (or bamboo strip) from contacting the surface of the steel to cause deep scratches.
Third, when changing to different types of sandpaper, the polishing direction should be changed from 45° to 90°, so that the streak shadow left by the polishing of the former type of sandpaper can be distinguished. Before changing the different types of sandpaper, the polished surface must be carefully wiped with 100% pure cotton and a cleaning solution such as alcohol, because a small gravel left on the surface will destroy the entire polishing work. This cleaning process is equally important when polishing from sandpaper to diamond polishing. All pellets and kerosene must be completely cleaned before polishing continues.
I believe that after holding the above several polishing technical points, it will definitely help to improve the appearance of the hand-made board and the rapid mold.
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn