Thermal Gas Mass Flowmeter,Thermal Gas Mass Flow Meter,Thermal Mass Flow Meter,Thermal Mass Air Flow Meter Jingsu Huaerwei Science and Technology Group Co.,Ltd , https://www.hewflowmeter.com
The problem of deviation of the steel plate, once deviation occurs, it will affect the production efficiency and product qualification rate of the machine.
So we must understand how to correct these mistakes. After a long period of research and exploration, we have come up with a way to adjust this problem: If the equipment board runs to the right, it needs to be ironed to the left corner.
Or flatten the roller on the right. The first axis will be smoothed and the first axis will be flattened. The roller above should be consistent with the roller below. If it is flat, the following should also be flat and evenly symmetrical. The roller cannot be changed. If it is not enough, first adjust the four corners of the front and rear rows of the color steel tile presser from the big frame to the same height at the upper end of the shaft, and then from the first row to the last row, find a line. Straighten, check if the lower axis is on a horizontal line and adjust the left and right sides of the lower axis to level. The first row and the last row of the color steel tile equipment find a good point of symmetry, and then tighten the two sides to lock the mother, pull a straight line in front of the center of the middle wheel, after the adjustment of the gap between the upper and lower shafts, The machine can be adjusted along a straight line. In fact, the board remediation remediation method requires us to produce and test for a long time. Different reversing directions have different remedies, but one thing to note is that no matter whether it is the mechanical roller or other parts, it needs to be aligned on both sides, only two sides. Alignment can maintain symmetry and the shape of the product will be regular.
Pressing machine deviation processing method
The method of processing the deviation of the tile press machine will inevitably cause such or such problems in the production process. The most common one is the color.