We have a lage numbers of Plain Panel Mouldings/panel moulding available,and we also design its own Polyurethane Corner to match.
If you want to evoke an atmosphere of stately homes, majestic hotels or huge castles, you can use DSM Decor Plain Panel Mouldings, various sizes, shapes and styles are available,they are very light, easy to install and paintable.
You may use Plain Panel Mouldings,Plain Mouldings,Door Panel Moulding Kits,Door Panel Mouldings,Panel Molding,trim moldings to create wainscoting or frames on the walls and ceilings. As a result, Plain Panel Mouldings offer endless combinations to create charming spaces as you image.
Advantages: Plain Panel Mouldings,Plain Mouldings,Door Panel Moulding Kits,Door Panel Mouldings,Panel Molding,Wall Panel Moulding,Decorative Panel Moulding Suntronic New Materials Technology Co., Ltd. , https://www.dsmdecor.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Bearing professor helps you analyze the causes and disposal methods of bearing overheating Bearing professor helps you analyze the causes and disposal methods of bearing overheating
The professor gave us a description of the causes and disposal methods of bearing overheating from seven aspects. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
Reasons for motor bearing overheating and disposal methods:
1, the bearing is damaged. Should be replaced.
2. The rolling bearing grease is too little, too much or has iron scraps and other impurities. The bearing grease capacity should not exceed 70% of the total volume; those with impurities should be replaced.
3. The shaft and the bearing cooperate too tightly or too loosely. When it is too tight, it should be ground from the head; when it is too loose, it should be set to the shaft.
4. The bearing and the end cap cooperate too tightly or too loosely. The bearing chamber is processed when it is too tight; when it is too loose, the steel sleeve is set in the end cover.
5. The two caps or bearing caps of the motor are not properly installed. Install the end cap or bearing cap into the flat; tighten the screws.
6. The belt is too tight or the coupling is not properly installed. Adjust the belt tension; proofread the coupling.
7, the sliding bearing lubricant is too little, there are impurities or oil ring stuck. Should be refueling, new oil; repair or replace the oil ring.
Recommend to friends comments close window Bearing related knowledge The use of imported bearings in the common sense of work and work and the use of technical energy-saving heat treatment skills and equipment in the bearing profession (3)
Skf bearing angle touch ball bearing imported bearing division method Professor's trick: the layout and characteristics of spherical roller bearings
This article links to http://
Please indicate the bearing network http://
Previous:Pre-disposal method for rusting of FAG bearing outer surface Next:Differential depiction of adjustable clearance rolling ball bearing (1)
1. PU (Polyurethane) material is Eco-friendly materials
2. Lasts longer than MDF or wood mouldings.
3. Designed for interior and exterior use.
4. Easy to install and will not crack, crumble, or warp.
5. Low cost: The surface painting is finished and installation time is very short, can be planned, sawed, nailed, and glued by yourself. 80% cost save than using wood and concrete.
6. Fire-proof: Reach the standard of no combustion.
7. Water-proof: No moisture absorbing, water permeation, and mildew arising.
8. Anti-erosion: Resist acid and alkali.
9. Light weight: good resiliene and tenacity, light and hard.
10. Styles and Colorful: Different Colors and Types are available.
Bearing professor helps you analyze the causes and disposal methods of bearing overheating
Source: China Bearing Network Time: 2013-12-07