Led Night Light,Projection Small Night Light,Led Star Projector Light,Rechargeable Night Light Shenzhen You&My Electronic Technology Co., Ltd , https://www.ymledtrade.com
Rotor pump installation and operation method Raiders wide
[Asia Pump Network News] rotor pump, also known as gel pump, cam pump, clover pump, universal pump, etc., are volume pumps. Now widely used in food and beverages, fruit concentrates, paste products, cosmetics, pharmaceuticals and chemical industry, play an important role in daily life. However, people do not know how to install and operate it. Xiaobian following for everyone to answer specific, to help you better use the rotor pump. Rotor pump installation and operation method Raiders First, the installation of the rotor pump 1, the rotor pump and the motor shaft connection, should first correct their level and ensure that both coaxial rear coupling can be installed, otherwise, will cause the machine Damaged parts. 2, because the rotor pump is a fixed capacity pump, displacement per revolution, once the process for some reason to stop working and the pump is still working, then the pump pressure will rise indefinitely, eventually leading to seal leaks, mechanical damage Such as accidents, for which we must take effective preventive measures. Example 1: With the upper and lower processes should be chain, when the next process downtime, stop the pump at the same time. Example 2, the output of the pipeline can be installed safety valve and overpressure circuit system, once over-pressure will be automatically unloaded. 3, if the rotor pump control valve, it can only be installed in the pump inlet pipe, outlet pipe should not be installed on the control valve, easily lead to over-pressure error. After all the installation, should conduct a comprehensive inspection, including mechanical parts, electrical wiring, etc., and then hand pump the pump 3 to 5 turns to observe whether there is any stuck or loose phenomenon until normal, and then through the electricity Test run, if found abnormal, due to stop overhaul, paternity everything after the normal delivery. Second, the rotor pump operation Rotor pump operation is convenient and safe, as long as the button, turn on the power, they began to work properly, to ensure that the pump can work better, but also pay attention to the following essentials. 1, before opening the rotor pump: first check whether the parts of the pump intact, out of the valve on the pipeline are all open, in short, must ensure that the parts intact, smooth piping. 2, in the open rotor pump: it must be the next process equipment to start work, and then, to start the pump. 3, the rotor pump in operation, should always pay attention to the action is normal, such as the discovery of the pump before the stop flow or blockage after the phenomenon should be promptly shut down, remove the fault and then boot. 4, when the entire line to stop working, according to the process in turn downtime, that is, after the pump stopped, then stop the pump behind the relevant equipment. For any mechanical equipment, normal maintenance work done well, it is not only reflected in the production is normal, more important directly affect the use of machinery and equipment ordered, for the pump, of course, is no exception, to this end, pay attention to the following Maintenance work. Industry Internet (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: Zeng Fenfen (QQ / WeChat:) http://beng.liuti.cn/ (Service Hotline:)