When home decoration, you must carefully check the quality of the floor decoration, do a good job acceptance. 1, see the color of the floor is the same If the color difference is too large, directly affect the appearance, you can ask for exchange; if the color is too consistent, almost no color, it depends on the floor surface pattern is the same. 2, see if there is a sound floor When walking on the floor during inspection and acceptance, the footsteps must be increased. In particular, the wall and door openings must be checked and accepted. If there are sounds, repeat the walk and determine the specific location of the sound. In this case, you can ask to remove the resurfacing. 3, acceptance of the floor deformation, warping Acceptance method is to use a 2 meter long ruler, leaning on the floor, the flatness should not exceed 3 mm. 4, the acceptance of the baseboard Baseboard and door frame clearance ≤ 2 mm; skirting line spacing between joints ≤ 1 mm; baseboard and floor surface clearance should be in the range of 3 mm to 5 mm; height difference of the baseboard buckle should be ≤ 1 mm. 5, the acceptance of the buckle The door clasp should be installed directly under the door. It is advisable not to leave the inside and outside of the door after closing the door. The gap between the clasp and the door is between 3 mm and 7 mm, and the door can be opened and closed freely. The buckle should be installed firmly and stably. You can kick the middle part of the buckle to check if the sides of the buckle are tilted or loose and there is no abnormal sound. 6, the final acceptance of the floor surface is a blink, cracks, scratches Commonly due to the untreated keel, there are locusts inside. Floor Construction Acceptance Flooring Installation Home Improvement Home Improvement Home Furnishing ZHEJIANG KINGSIR VALVE CO., LTD. , https://www.kingsirvalves.com