Mosaic products do not equal edge products: The use of high-quality mosaic products of the same specifications is greater than that of normal sheet materials: Plate Single Bowl Kitchen Sink,Single Bowl Stainless Steel Sink,Single Bowl Sink,Single Basin Stainless Steel Sink Guangdong Huayou Hardware Products Co.,Ltd , http://www.gudsink.com
For a mosaic product, if it is specifically targeted at the purpose of digesting internal trimmings or scraps, it is only necessary to add a little material cost to the processing cost if there is no quantitative or small amount of production and sales. However, when it is sold or produced as a mass production, a large-scale standardized product that satisfies the market demand, or a large-scale project, the general edge material or waste cannot satisfy the Needed. At this point, if normal production and supply are to be carried out, then it will only be realized if there is a large amount of raw materials or open storage materials. Therefore, from this point of view alone, even if we adopt the method of purchasing cheap and small materials, the cost is far from being comparable to that when we use edge materials. Therefore, the concept of cost has increased its weight.
For the mosaic materials, if you really want to achieve a high level of quality, you can see from the above production process that the actual material of the mosaic product of the same specification is larger than the actual material of the plate. Specifically, there are the following four points: First, in the process of producing granules for a mosaic product, it is necessary to split the plate (final medium) into the desired granules according to the requirements of the standard cell block, and the granules are smaller, and in comparison However, the width of the blade is large, and a plate is made into a standard block. The loss in the blade width may account for more than 15% of the loss. This is particularly prominent in the processing of small-sized mosaic products. The second is that the color of the materials is basically the same. This requires the use of materials in the process of discarding those materials that are inconsistent in color, which in turn forms part of the direct loss. Third, in the process of media and vibration, the direct loss of some materials is caused by inaccurate media or broken vibrations. About 10%; Fourth, because the mosaic particle itself is not all square or rectangular, it also has its own loss of utilization, which is more prominent in the mold products.
Interpretation of misunderstandings of materials used in stone mosaic products
There is an incorrect concept in the market, that is, all mosaic products are processed from scrap or scrap, so the cost is very low, but it is not.